1. Missed the live Ask the Expert event?
    Catch up on the conversation with Ken Hutcheson, President of U.S. Lawns, in the Franchising forum.

    Dismiss Notice

Truckcraft TC-120 Aluminum Dump Insert - $4000

Discussion in 'Marketplace' started by LawnGuy73, Jan 20, 2009.

  1. LawnGuy73

    LawnGuy73 LawnSite Bronze Member
    Messages: 1,946

    This is a 2004 model Truckcraft TC-120 aluminum dump insert. It is in good used working condition. It does have the normal dents and dings but has plenty of life left in it. In November of 2008 I had the pump and motor professionally gone though at Truck Utilites in St Paul. At the same time they replaced the wiring and the circuit breaker. So these items are nearly new. The insert also comes with the SlipStream Cab guard (not pictured) which was put on new in the spring of 2008. I'm asking $4200/best offer, and the insert is ready to be picked up today in Shakopee, MN.

    Here is more information on the unit itself taken for the Truckcraft website.

    The TC - 120 ULTRA has been engineered from the ground up to provide users with years of maintenance free service. The body and frame are designed and constructed entirely of aluminum and stainless steel to provide durability and resistance to rust and corrosion. TruckCraft's innovative use of aluminum alloy extrusions welded to sheet aluminum enables them to offer a pickup dump insert that is 300 - 350 lbs. lighter than comparable steel units. The result is a unit that weighs less, hauls more payload, and will be less expensive to operate and maintain. This classy accessory for your pickup is the first of its kind available through nationwide distribution.

    Rigid Floor of Extruded Aluminum - The floor is constructed of aluminum alloy plank extrusions that provide rigid reinforcement every 5". This "tongue and groove" design, proven in roll-back car carriers, keeps the floor from deflecting under heavy loads and eliminates the "washboard effect" seen in light-duty sheet-bed models.

    Aluminum Rails add Overall Strength - The TC-120 design utilizes a polished and fluted aluminum alloy extrusion on the top box rall of the body sides and the top and bottom of the tailgate. This provides the maximum strength at a minimum weight while greatly enhancing the product's overall appearance.
    Low Bed Height - only 3-1/4" above pickup bed - The 2.4 cubic yard payload offered by the TC - 120 is positioned only 3-1/4 inches above your pickup floor. This feature adds greater volume and keeps the vehicle's center of gravity low. It also reduces the height that heavy objects must be lifted into the bed.

    All Aluminum Bed - 48 1/8" x 98" - The bed holds a full sheet of plywood with the tailgate closed. The side board installation kit (shown) used with your boards will increase the volumetric capacity from 2.4 cu. yds. to as much as 5 cu. yds.

    Three-way Tailgate - The TC-120 tailgate has a paddle latch and can be opened and closed with just one hand. The gate can easily be removed for complete access. Control chains can be adjusted for using the tailgate as a spreader.
    3 Stage Telescopic Lift and Cab Protector - The ULTRA hoist system utilizes a heavy duty, three stage, telescopic cylinder with chromed rod sections. The hoist has been custom designed by TruckCraft to lift 7,000 lbs. to a 47 degree dump angle in just 18 seconds. The aerodynamic cab protector (shown) provides low wind resistance and great visiblity. The cab protector and a full tarp system are options that can be easily added to the TC-120 at any time.
    Power Unit and Standard Remote Dump Control - A compact, one-piece power unit is mounted directly behind the cab in close proximity to the hoist. The remote control buttons activate the motor/hydraulic pump from within the cab or up to 12 feet away from the cab. One 12 volt battery cable is the only electrical connection required.
    150 amp resettable in-line circuit breaker- safeguards power in, and also allows manually switching off power under hood to disable unattended insert.

    Insert weight- only 420 lbs.
    <2 Hour installation


  2. J&R Landscaping

    J&R Landscaping LawnSite Fanatic
    Messages: 5,095

    Bump for a good unit! I have the same unit in my f250 and love it!!
  3. LawnGuy73

    LawnGuy73 LawnSite Bronze Member
    Messages: 1,946

    Thanks man!
  4. supercuts

    supercuts LawnSite Silver Member
    Messages: 2,806

    arent they $4500 new?? is it $4000 or $4200?? you have two prices listed.
  5. pj550v12

    pj550v12 LawnSite Senior Member
    Messages: 302

    5 years old and you're offering a total of $100 off the origional price? What a joke
  6. pj550v12

    pj550v12 LawnSite Senior Member
    Messages: 302

    Edit: Thinking of a different insert, these are in fact about $4600 new. I still think the price is high, but not as bad as I thought. My bad
  7. LawnGuy73

    LawnGuy73 LawnSite Bronze Member
    Messages: 1,946

    Sold Sold Sold


Share This Page