1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

Ultravac question

Discussion in 'eXmark' started by WoodBrothersLC, Jun 15, 2004.

  1. WoodBrothersLC

    WoodBrothersLC LawnSite Senior Member
    Messages: 418

    My brother and I have been looking at the Lazer Z Hp 52/23 and will need a bagger for it but I was wondering how far out the impeller on the ultravac stuck out and need to know if it will fit on a 6.5 ft trailer
  2. T Edwards

    T Edwards LawnSite Member
    Messages: 230

    Yes, it will fit. Ours has 4-5" of space on each side.
  3. WoodBrothersLC

    WoodBrothersLC LawnSite Senior Member
    Messages: 418

    Hey Terry, I know you are busy but it shouldn't take a day to answer a very simple question

  4. Blessed 1

    Blessed 1 LawnSite Senior Member
    Messages: 516

    Mines (60") fits tightly but it fits. It only takes 30 seconds to take it off if nessesary.
  5. eXmark

    eXmark Manufacturer / Sponsor
    Messages: 4,258


    You are correct. I should be able to answer your question much quicker than I have.

    The vac adds approximately 12" to the width of the machine. I don't however recommend transporting the mower with the blower attached unless you completely lower the deck. Even better is completely lowering the deck onto a couple of blocks of wood so the chains go slack. By doing this your releaving some of the weight from the blower and the 25 lbs. of wet grass or so that can be under the deck.


  6. WoodBrothersLC

    WoodBrothersLC LawnSite Senior Member
    Messages: 418

    That is what I needed to find out before I thought I was going to get one!

    Thanks Terry, Blessed and Edwards

Share This Page