valve ID

Discussion in 'Irrigation' started by Dirt Boy, Jul 17, 2012.

  1. Dirt Boy

    Dirt Boy LawnSite Senior Member
    Messages: 489

    Ran across these valves, 1 has a bad solenoid, but neophyte that I am, I haven't a clue what brand it is. Can you help?

    Thanks

    photo 2.jpg

    photo 3.jpg
     
  2. irritation

    irritation LawnSite Gold Member
    Messages: 3,422

    never seen anything like it.
     
  3. DanaMac

    DanaMac LawnSite Fanatic
    Messages: 13,171

    It's a toro. But I forget the model number. Great reliable valve, pita to service.
    Posted via Mobile Device
     
  4. mitchgo

    mitchgo LawnSite Silver Member
    Messages: 2,895

    It is toro but don't know the model
     
  5. Dirt Boy

    Dirt Boy LawnSite Senior Member
    Messages: 489

    OK, Thanks, I was assuming it was a Toro as well, but can't see any ID on it.
     
  6. cjohn2000

    cjohn2000 LawnSite Senior Member
    Messages: 567

    Its either a 250, 254 0r a 252. Hope this helps:waving: All those models I listed are basically identical.
     
  7. NC_Irrigator

    NC_Irrigator LawnSite Bronze Member
    from NC
    Messages: 1,444

    a 252 with the metal rings around where the thread ends are.

    most all 250 series parts interchange for the 1" models.
    diaphrams solenoids top ends.. etc.
     
  8. ArTurf

    ArTurf LawnSite Platinum Member
    Male, from Ark
    Messages: 4,072

    It's a Toro 250 something. Go to sprinklerwarehouse.com and click "valve ID".
     
  9. DanaMac

    DanaMac LawnSite Fanatic
    Messages: 13,171

    The screws on those tend to be soft, and easily stripped. Clean out all the dirt from the top of the screw, and use the right sized tip to remove them.
     
  10. Dirt Boy

    Dirt Boy LawnSite Senior Member
    Messages: 489

    Thanks, got it on order
     

Share This Page