walker dual rear wheel tire help

Discussion in 'Mechanic and Repair' started by TurfWarrior, Jul 24, 2011.

  1. TurfWarrior

    TurfWarrior LawnSite Member
    from nj
    Messages: 125

    i have a looks like 1999 if i read it right mtghs walker with the dual rear wheels. when i took it apart to replace the bearings i did not pay attention to where the two large nuts on the ends of the drive shaft go???? and maybe they were in the wrong place because one side was all screwed up. the ones that go on the inside of the bracket then you put the bolts through the bracket and into the shaft to hold it all together. The larger nuts on each end have the allen key in them also. lastly i remember the nuts being adjust just wide enough to fit inbetween the bracket but when you put it all back together it feels like you can go tighter pretty much fully tight so you each tire can spin still but to where there is a good 1/2- 3/4 gap now to where you suck the bracket in when you put the bolts in from the outside and that doesnt seem right. i dont know. who knows where they go??? thanks

Share This Page