1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

What' a REALLY good blade for a

Discussion in 'Lawn Mowing Equipment' started by Fuzzy1, Jun 25, 2013.

  1. Fuzzy1

    Fuzzy1 LawnSite Senior Member
    Messages: 369

    John Deere Z920R ZTR with a 54" deck ??? Stay with factory, or save a few bucks and go with the OREGON blades ??? Regular/Hi-Lift/MULCHING type ???

    AND ... who has the best overall prices on the set you recommend ???


    thanx ... ... ...


    <<<__ Bøb __>>>
     
  2. Jaybrown

    Jaybrown LawnSite Bronze Member
    Messages: 1,160

    I like the gator blades
     
  3. Vecchio Lawn Care

    Vecchio Lawn Care LawnSite Senior Member
    Messages: 905

    My 757 likes the high lift factory
     
  4. Ridin' Green

    Ridin' Green LawnSite Fanatic
    Male, from Michigan
    Messages: 17,063

    For a non MOD deck the G6's or G5's are very hard to beat for overall use, but the factory makes some darn good quality blades as well. The OEM high lifts's stripe better, but the G series blades chop the clippings up much better, while still leaving a decent stripe from a properly pitched deck.

    If you have a MOD deck, they don't do near as well with the G series blades as they do with OEM high lifts or OEM wavy mulchers (which I run under my MOD a lot of the time).
     

Share This Page