1. Missed the live Ask the Expert event?
    Catch up on the conversation about enhanced efficiency fertilizers with the experts at Koch Turf & Ornamental in the Fertilizer Application forum .

    Dismiss Notice

What blades to use with Quick Chute?

Discussion in 'Lawn Mowing' started by Kickin Your Grass, May 17, 2007.

  1. Kickin Your Grass

    Kickin Your Grass LawnSite Senior Member
    Messages: 479

    I was wondering what blades are the best to run on my 52" Turboforce deck with my quick chute? I have the highlifts that come on it. Maybe something that will mulch and/or side discharge.
     
  2. Kickin Your Grass

    Kickin Your Grass LawnSite Senior Member
    Messages: 479

    bump.>>>>>>>>>>>>>>>>
     
  3. Grits

    Grits LawnSite Silver Member
    from Florida
    Messages: 2,994

    I don't have a Quick Chute, but I run Gators when I mulch or side disharge. I would think these would do better than Hi-Lifts because less chance of leaving a row of clippings.
     
  4. Envy Lawn Service

    Envy Lawn Service LawnSite Fanatic
    Messages: 11,062

    Go to a Husqvarna or Yazoo/Kees dealer and get a set of their OEM wavy mulchers. The Turbo Force does use regular length blades with 5/8" center hole right?

    I know these fit the eXmarks and they are a better blade made by some other blade MFG. They have FMC stamped on them if you happen to know "who" that is.

    If you have to order them, allow 2 weeks for arrival... LOL.
    Husqvarna-Yazoo sucks... LOL.

    Don't do the OEM eXmark blades... they suck in my opinion.
    Not enough lift and they flex too easily under load.




    I don't like gators for mulching with a closed deck.
    They cause too much blowout and suspend too many clippings up in the deck.
    As a result, the deck loads up and eats a lot of power...
    And when you stop to turn, the deck will dump clippings.
     

Share This Page