1. Missed the live Ask the Expert event?
    Catch up on the conversation about enhanced efficiency fertilizers with the experts at Koch Turf & Ornamental in the Fertilizer Application forum .

    Dismiss Notice

Where do you all have your scalp wheels set on ZTR's?

Discussion in 'Lawn Mowing' started by beaver29, Aug 1, 2005.

  1. beaver29

    beaver29 LawnSite Senior Member
    Messages: 279

    I have my anti-scalp wheels on my gravely 252z set to where they roll all the time when cutting at 2" or below. Should I run them like this? I think my holes are 1" apart and thats to much gap in between. I should have one more hole between the 2 holes I have now. If I pick them up a hole then I scalp bad on hilly lawns.
  2. LwnmwrMan22

    LwnmwrMan22 LawnSite Platinum Member
    Messages: 4,372

    If you have your owner's manual, it should say in there, if not on a sticker on the top of your deck.

    Each manufactuer is different.
  3. Runner

    Runner LawnSite Fanatic
    Messages: 13,494

    Wherever they don't scalp. If they're rolling all the time, keep them oiled, and they will have to be replaced a little more ogten. It does beg the question, though...Why are you cutting below 2 inches?
  4. beaver29

    beaver29 LawnSite Senior Member
    Messages: 279

    I have a customer that likes her grass cut real short. Thats why I asked.

Share This Page