1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

wright stander wont move!!!

Discussion in 'Mechanic and Repair' started by crlawncare01, Mar 20, 2012.

  1. crlawncare01

    crlawncare01 LawnSite Member
    Messages: 35

    I have a wright stander fixed deck also the deck is 61 inch. ( about 5 years old)

    today the crew was cutting grass and the mower started to slow down.. the driver shut it off and called me saying he thinks it is low on hydro fluid...

    I met them at the lot took the cap off and it was low so i added fluid untill full.

    i started it back up let it run for a little bit and it will not move at all. i called a local dealer they said the pumps and the motors went bad proble but it did not run out of fluid...

    1. is there something i have to do when it runs really low? ( leveler to bleed it)

    2. the safty switch i spilt a little fluid on it could i have messed it up?

    anything will help guys thank you.
  2. pugs

    pugs LawnSite Gold Member
    Messages: 3,024

    Raise the back end up and run it forward and back with wheels off the ground to bleed it.

    Try replacing the filter. Generally both sides dont stop working at once.
  3. piston slapper

    piston slapper LawnSite Platinum Member
    Messages: 4,329

    While you're at it.....make sure the hydro belt and relief valves are tight.
    Posted via Mobile Device
  4. crlawncare01

    crlawncare01 LawnSite Member
    Messages: 35

    well its almost fixed!!!!! what is was (rookie mistake ) should have looked in the first place...

    it was the belt thanks piston slapper and pugs for your input.. im glad it was a easy fix

Share This Page