1. Missed the live Ask the Expert event?
    Catch up on the conversation about fertilization strategies for success with the experts at Koch Turf & Ornamental in the Fertilizer Application forum.

    Dismiss Notice

Your tips for preventing striping a lawn

Discussion in 'Pesticide & Herbicide Application' started by lawn_j0ckey, Feb 22, 2004.

  1. lawn_j0ckey

    lawn_j0ckey LawnSite Member
    Messages: 15

    Post 'em.
  2. NCL

    NCL LawnSite Member
    from NJ
    Messages: 132

    overlap your passes.
  3. precisioncut

    precisioncut LawnSite Senior Member
    Messages: 653

    NCL-only tip I could have given
  4. philk17088

    philk17088 LawnSite Fanatic
    Messages: 17,386

    Calibrate and keep your equipment clean and repaired .
  5. grassguy_

    grassguy_ LawnSite Senior Member
    from Ohio
    Messages: 633

    Depending on whether you are spreading dry or spraying liquid. If using a spreader usually it's a case of making passes either too far apart(most common) or making passes to close, (triple overlapping, not so common). Having ports in your spreader clogging or not open will effect the distribution pattern. Lesco's spreader has a tendency to spread more to the right than to the left unless your adjusting the flow from the adjustable port with the slide plate underneath. When spraying with a liquid the same problem with pattern can occur with not making passes close or too far apart. too many that spray have a tendency to look down and point the nozzle too much toward the ground making a more concentrate pattern in the center of he path they are walking and not getting the pattern back to where the previous pass was made. Likewise the triple overlap problem can occur as well with spraying to far over the previous pass. Speed of app can effect pattern too, by making to much spray applied going uphill while going to fast when going downhill, not that common simply because most that have been doing treatments for any length fo time avoid the up/down scenario by applying with the hill when possible.

    DUSTYCEDAR LawnSite Fanatic
    from PA
    Messages: 5,132

    hire a professional:p
  7. Outback Designz

    Outback Designz LawnSite Member
    Messages: 89

    Always at least one smarta@# in the group. :rolleyes:
  8. NCSULandscaper

    NCSULandscaper Banned
    Messages: 1,557

    The correct way to do it is do half rate in one direction and do the other half at a 90 deg. angle from the first. For granular. Liquid its best to use a marker dye in your tank so you can see where you have sprayed.
  9. GroundKprs

    GroundKprs LawnSite Bronze Member
    Messages: 1,969

    If you want to spread correctly, you need to calibrate yourself with your spreader(s) and sprayer(s). These pages will give you an idea on granular Spreader calibration.

    There is also a proper procedure for calibrating liquid sprayers, whether a single nozzle on a backpack or multiple nozzles on a boom.
  10. MacLawnCo

    MacLawnCo LawnSite Bronze Member
    Messages: 1,847

    Jim, would you mind sharing that, or pulling it up if you have already. Thanks

Share This Page