1. Can’t make it to the GIE+EXPO 2017?
    LawnSite brings the trade show floor to your fingertips with our new GIE+EXPO 2017 Sneak Peek video series debuting now in the Lawn Mowing forum.

    Dismiss Notice

ZT 2800 s leaking

Discussion in 'Hustler Turf Equip (Archived)' started by rjcruiser, Jan 8, 2011.

  1. rjcruiser

    rjcruiser LawnSite Member
    Messages: 18

    Went to start the mower today after about 2 months of inactivity and noticed some oil on the shed floor. Started it up and both hydros were leaking. Both from the same spot...on the underside, two small bolts hold a cover on and theres a circular seal around that cover. That is where it appears the leak is coming from. Can I get new seals? Also, what lb torque are those bolts to be at? I already tried to tighten one up and it just sheared right off....so now I got to replace a bolt as well and extract the stud :(

    It is a Mini Z 42" model number 928200. Has 240 hours on it.
  2. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Messages: 9,769

    E-mail me and I will reply to you with the service / parts manual on the hydro units.
  3. rjcruiser

    rjcruiser LawnSite Member
    Messages: 18

    e-mail sent....thanks!
  4. okievarmint

    okievarmint LawnSite Member
    Messages: 30

    Hustler part# for charge pump cover o-rings: 603223 MSRP= 1.30
    Be sure the cover and bolts go on in the EXACT position they were removed.
  5. rjcruiser

    rjcruiser LawnSite Member
    Messages: 18

    Ended up the cover was warped. Ordered the cover only and it is to be here this week. I'll put it all back together and hopefully it will be sealed nice and tight.

    Thanks for the advice.

Share This Page