Lawn Care Forum banner

Echo srm2620 vs srm 3020

1 reading
14K views 19 replies 11 participants last post by  Merkava_4  
#1 ·
What your opinion on these?
these are not the high torque models
I’ve heard the high torque ones aren't any good
 
#5 ·
I'm also contemplating a srm 225 for quick and light stuff
any thoughts?
yes I know it's not commercial but for light stuff maybe?
Having had both, the 2620 will do it all. The 225 will handle probably 90% of what you would throw at it for a normal grass cutting route.
 
#20 ·
I always hear the flex cable shaft having more vibrations than a solid steel shaft. Here's one example I read a few minutes ago:

Shindaiwa T262 (Same as Echo SRM2060)
Purchased in April of 2019

Pros:
  • Easy starting
  • Weighs 12.4 lbs on paper but in real life, it was very well balanced and did not feel heavy at all even after long days of usage.
  • Pretty good on fuel
  • Very strong motor
  • Fast cutting head for quick clean cuts
  • Speed Feed 400 head is very use to and reload although the eyelids sit a little low. So, you have to be careful not to lower the head too much or you will scalp the grass.

Cons:
Only 1 and the biggest issue I had: excessive vibrations down the shaft at mid to full throttle. It started to develop at about 15-20 hours. Dealer tried to remedy the issue but it just got worse over time to the point where your hand would go numb. Dealer felt that the problem stemmed from the flex cable shaft used in the T262 and T302 models. He noted that the T235 which has a a solid steel shaft did not exhibit the same issue.