Lawn Care Forum banner

mower won't fit through gate

12K views 12 replies 10 participants last post by  Precision  
#1 ·
What about taking the gate apart just for the cutting.
Only on chain link of course.
 
#3 ·
I have some small ones but I want to use the 48". Don't have the money right now for either the w/b or 34/36 rider.
I just spent a half hour reading the debate about these concepts.
I am just thinking that it would only take a minute with a cordless to take the four screws off the corner and pull the fence back a little.
I know this sounds extreme but when there it grass on the other side, I've got to mow that stuff...
 
#9 ·
If there ain't that much grass, learn to do it with your trimmer.

I've got a couple of yards I just use the trimmer, faster than push mowing and I can't get the 48" wb in the gate without jockeying through the gate.

They're areas of about 1k sq ft. each, takes about 5-10 minutes with an Echo 261t.

After 5-10 years of trimming, you get pretty smooth at trimming. Even to the point where you could do a whole yard if that's all the equipment you had for whatever reason.

Now I'm trying to work on my trimmer's striping pattern.
 
#13 ·
Time is money.

If you are spending the time taking apart and reassembling a fence each week, I would just avoid those lawns until I could either afford a 36" or broke down and bought a throw away 21-26".