Lawn Care Forum banner

Snapshot application tool

5.7K views 23 replies 14 participants last post by  GravelyGuy  
#1 ·
What are you guys using to evenly apply snapshot to beds? I'm using a hand crank spreader but it only holds five lbs. Seems like I spend as much time refilling it, as i do applying, when doing larger beds.
 
#12 ·
Yeah they are inexpensive but not as efficient as the blowers. You can conserve the product a lot better in comparison to blowers though.
pouring from a 50lb bag is too difficult so I started going from the bag to a 5 gallon pail with a lid. Holds probably 2/3 bag to keep ability to pour through large funnel. Pretty efficient process. I would have each applicator take 2 spreaders in case of encountering larger areas. You can almost cover as much area with one but with 2 you can go a lot further between fills.
 
#23 ·
I’m not looking at the label but isn’t it like 3 or four pounds covers 1000 square feet?
So five pounds would cover approximately 1260 SF
What kinda beds are you trying to treat all at once , a Walmart or something?
A typical resi bed being 6 feet wide… that’s over 200 lineal feet per little hopper from a hand crank

you CAN put 600 pounds per acre per season , but that’s not a recommended dose in one application.

are you either over applying or doing massive beds?
 
#24 ·
I'm not looking at the label but isn't it like 3 or four pounds covers 1000 square feet?
So five pounds would cover approximately 1260 SF
What kinda beds are you trying to treat all at once , a Walmart or something?
A typical resi bed being 6 feet wide… that's over 200 lineal feet per little hopper from a hand crank

you CAN put 600 pounds per acre per season , but that's not a recommended dose in one application.

are you either over applying or doing massive beds?
I was wondering the same thing.